Cleveland® HGA-2 Center Cut General Purpose High Helix End Mill, 3-3/4 in OAL, 2 Flutes, 1-3/4 in, 7/16 in Cutter
Cleveland® End Mill, Center Cut General Purpose High Helix Single End Square End, Series: HGA-2, 7/16 in Cutter Dia, 3-3/4 in Overall Length, 1/2 in, 1-3/4 in Maximum Depth of Cut, 2 Flutes, Spiral Flute, 1/2 in Shank Dia, Right Hand Cutting, 37 deg Helix Angle, Straight with Weldon Flat Shank, HSS, TiCN Coated
- 2-Flute end mills have greater chip ejection capacity and are ideal for slotting
- Coatings reduce heat and abrasion to increase tool life
- The increased lubricity of the coating surface reduces material adhesion and built-up edge, enabling even higher feed rates
- Coatings reduce the amount of torque required for machining to allow more efficient use of equipment
- TiCN (titanium carbonitride) coating in blue-gray color for very aggressive machining of stainless steels and non-ferrous materials
- TiCN coating is extremely hard, wear resistant and increase machining speeds 35 to 50% versus bright speeds
- Applicable on aluminum, copper alloys, magnesium and brass